Jump to content

[SOLVED] Clover r4630 on E7450 - macOS 10.13.6


acquarius.13

Recommended Posts

Hi there, 

 

I start this topic to know if anyone else found issues after installing new clover updates.

 

In my case my E7450 doesn't boot at all. After clover logo, I select macOS but the screen remain switched on, but no apple logo appears..so no boot. And SSD seems not to work (so no disk activity).

 

Did you find a similar issue? 

How may I solve it?

Lilu version 2.2.0

 

Thanks

 

Marco

Link to comment
Share on other sites

  • Moderators

No issue on my end but I'm still running 10.12.6.

Where did you get Lilu 2.2.0?

The newest I'm running is 1.2.6

Do you have your Installer USB?

Boot with that and then select your installed drive.

If not, then you could try maybe disabling Lilu.kext from the main menu

Link to comment
Share on other sites

Hi guys,

 

@Jake Lo I was wrong in lilu version (I posted the shiki version). Currently I'm running 1.2.3. Could be this one the cause of the problem? 

@Bronxteck @Jake Lo I post you here my EFI/clover folder: could you guys have a look and tell me if there is anything I have to switch on/off on clover installer?

 

My bios is A19

 

Thanks again

 

 

Link to comment
Share on other sites

I tried to remove Shiki, IntelGraphicsFixup, and IntelGraphicsDVMTFixup and placing whatevergreen.kext but the boot sequence interrupts at a certain time and then reboot automatically.

I didn't perform a verbose since I didn't expect this behaviour.

Should I do something else?

Link to comment
Share on other sites

  • Moderators

you could still select verbose + debug 0x100 mode at Clover by pressing the spacebar

Perhaps put IntelGraphicsDVMTFixup back. The current version might not have integrated it yet.

If you set fakeID again, you could be able to boot again.

Link to comment
Share on other sites

×
×
  • Create New...