Jump to content

E7240-Mojave Installation Guide Needed


theeama

Recommended Posts

Hello Guys. I am currently running HS Intel I7, 8GB Ram 500GB ssd.  I would like to update to Mojave but i have a few concerns and questions. 

 

1. Do I have to perform a clean install or i can update straight from the app store. 

2. What Kext do i need or config.plist file is needed to make the transition over. 

3. Is their a guide that already exists ? 

Link to comment
Share on other sites

Hi, I have Mojave installed on my E7240, and I'm using following kexts and drivers:

tQphO5l.png ccsKSZ6.png

 

If you want, I placed my guide for installing Mojave on E7240 here: https://www.hackintosh.com.pl/forum/viewtopic.php?f=11&t=29 

The guide is in Polish, but you can use translator if you want. In this guide I placed my Clover EFI folder, config and the drivers I used for.

 

 

 

Link to comment
Share on other sites

  • Moderators

@theeama

 

Download the latest Clover and install with the following settings

  • Install for UEFI booting only
  • Install Clover in the ESP
  • Drivers64UEFI\DataHubDxe-64
  • Drivers64UEFI\FSInject-64
  • Drivers64UEFI\SMCHelper-64
  • Drivers64UEFI\ApfsDriverLoader-64
  • Drivers64UEFI\AptioMemoryFix-64
  • Drivers64UEFI\PartitionDxe-64
  • Install Clover Preference Pane 

Now replace the attached files into /EFI/Clover. These are update files from your Clover folder.

Remove AppleHDA_ALC292.kext from /L/E

Repair permissions and rebuild cache

Reboot

Once you're rebooted and successfully login to OSX, you should now be able to upgrade from AppStore

E7240_Mojave_theeama.zip

Link to comment
Share on other sites

On 10/10/2018 at 6:04 PM, Jake Lo said:

@theeama

 

Download the latest Clover and install with the following settings

  • Install for UEFI booting only
  • Install Clover in the ESP
  • Drivers64UEFI\DataHubDxe-64
  • Drivers64UEFI\FSInject-64
  • Drivers64UEFI\SMCHelper-64
  • Drivers64UEFI\ApfsDriverLoader-64
  • Drivers64UEFI\AptioMemoryFix-64
  • Drivers64UEFI\PartitionDxe-64
  • Install Clover Preference Pane 

Now replace the attached files into /EFI/Clover. These are update files from your Clover folder.

Remove AppleHDA_ALC292.kext from /L/E

Repair permissions and rebuild cache

Reboot

Once you're rebooted and successfully login to OSX, you should now be able to upgrade from AppStore

E7240_Mojave_theeama.zip

Thank you. 

 

I did everything that you said downloaded through the app store launch the update it runs irestart boot back into clover select the update it begins to run for a few minutes then it flashes to black then continues then it makes a next flash but this time the screen stays dark nothing is on it. 

Link to comment
Share on other sites

×
×
  • Create New...