Jump to content

How to hackintosh a Latitude E5450


AmirBmirCmir

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

  • Moderators

Yes, make sure you plug in each port with USB2.0 and USB3.0 devices, then remove the non active ports.

Then save as a kext or export as an SSDT-xxx.aml and use with USBInjectAll.kext

 

From the above, it looks like your touchscreen is an USB device.  If it doesn't work OOB, then you'll probably need to use an app like touch-base.

Link to comment
Share on other sites

  • Moderators

Did you format drive as GPT prior to installation?

What error are you encountering? 

Which version of Clover are you installing?

Did you disable security?  

sudo spctl --master-disable

Please post screenshot of error.

Link to comment
Share on other sites

Did you format drive as GPT prior to installation?

Yes, I did

What error are you encountering?

It just said installation failed

Which version of Clover are you installing?

I was using the latest, v2.4k_r4945

Did you disable security?  

Yes I did this sudo spctl --master-disable

Please post screenshot of error.

I think I made mistakes, after clover failed I try to replace bootpack in efi partition with e5450 bootpack, from here:

The result is sierra cannot boot after restart. So I can't screenshot the error.

Also, I cannot generate ssdt.aml because my processor was not recognized. But, since it said it was not mandatory I am not worry too much :)

 

The bigger problem, I also lost windows efi (it not shown in clover) :D  & I don't have the recovery media

Link to comment
Share on other sites

I will try to access with verbose mode. Last time I tried,  I still had problem with clover installation. I can open the .pkg, change install location & customize install, click install, writing files and ended with installation failed.

Link to comment
Share on other sites


×
×
  • Create New...