Jump to content

E7270: stuck trying to install Mojave


jackbaurctu

Recommended Posts

  • Replies 26
  • Created
  • Last Reply

Top Posters In This Topic

  • Moderators

Replace this into /EFI/Clover and try again.

Set BIOS with the following settings:

Set to "Load Default", Apply, then set the following:

TPM = Disabled

Secure Boot = Disabled

UEFI = Enabled

SATA Operation = AHCI

Wake on Lan /WLan = Disabled

Enable Legacy Option ROMs = Disabled

 

Don't use Clover 4988, I have the same boot failure. Use and older version.

Link to comment
Share on other sites

  • Moderators

You're probably missing HFSPlus.efi

Make sure to replace the files into /EFI/Clover, not replace Clover with the bootpack

Install clover with the following settings

  • Install for UEFI booting only
  • Install Clover in the ESP
  • Drivers64UEFI\DataHubDxe-64
  • Drivers64UEFI\FSInject-64
  • Drivers64UEFI\SMCHelper-64
  • Drivers64UEFI\ApfsDriverLoader-64
  • Drivers64UEFI\AptioMemoryFix-64
  • Drivers64UEFI\PartitionDxe-64
  • Add to Drivers64UEFI\HFSPlus.efi (Not included in Clover installer)
Link to comment
Share on other sites

  • Moderators

add the following boot arg until you finish installing. Basically it needs the Graphics kext to be cached before the patches from the Config file will work. I think I have stated this a few posts above for another member.

At Clover, press "O" to get to Options. Append this to the end of the boot arg

 -igfxvesa

Link to comment
Share on other sites

  • Moderators

Can't really tell since the error occurred way before that last line.

Try this, go to Option during Clover boot.

Go down to graphics injector and change ig-platform-id to 0x12345678 and faked to 0x12345678

see if you could boot from that 

  • Thanks 1
Link to comment
Share on other sites


×
×
  • Create New...