Jump to content

[SOLVED] Install El Capitan on Latitude E5420 reboots


absint0o

Recommended Posts

  • Moderators

Let's start from beginning. Go to BIOS, set Load Defaults. Apply it. Then go to SATA Operation and set it to AHCI. Make sure it's on Legacy Mode, not UEFI.

When you create the install, make sure when you install Clover you select ESP and not UEFI. Then boot without cache.

Link to comment
Share on other sites

i've went to the BIOS and i set Default Options and i aplly them. after that i went to SATA Operation and by default it was set to AHCI. in the boot options it was on Legacy mode and not in UEFI.
 
my boot usb was created by following the steps in the Clover guide, and because of my laptop model i followed the "Note 1, post #2" for non UEFI BIOS.
 
in the installation i pressed spacebar and choose boot without cache, and then i've got this screen before it reboots:
 
post-97443-0-45873100-1473892383_thumb.jpg
 
i've follow every step from the guide but something is not working properly...thank you for your patience!

Link to comment
Share on other sites

×
×
  • Create New...