vaccinemedia Posted April 6, 2019 Share Posted April 6, 2019 I've done a clean install of Mojave 10.14.4 on a Dell Latitude E6440 with 4300M, 8GB RAM, 250GB SSD and Intel HD 4600 Graphics. I created the installer using the command line: sudo /Applications/Install\ macOS\ Mojave.app/Contents/Resources/createinstallmedia --volume /Volumes/"Untitled" --applicationpath /Applications/Install\ macOS\ Mojave.app --nointeraction Then installed the latest Clover and added the bare minimum drivers and kexts in order to run the installation. The installation went perfectly. It even felt like I was installing onto a real MacBook! Post install I installed Clover onto the main HD and copied over the EFI folder from the USB stick over the one installed by Clover. Using FixHPET in clover config I have managed to enable all USB and Bluetooth. The final issue is with audio. I have installed the latest AppleALC.kext and Lilu.kext and have used the option in Devices > Audio > Inject = 12 as per what I've found using a search. After rebooting, no audio. I've also tried using the AppleHDA_ALC292.kext and CodecCommander.kext in /Library/Extensions after removing AppleALC.kext and rebuilding kext caches and setting the inject to 1 and rebooting - no audio. I'm not sure what else to try as either method is so simple. I have not patched / used a dsdt and using Clover to handle all of the hot patching. Any advice would be well received! I've attached my current EFI folder as the laptop does not have an internet connection (no wifi as it's intel) so can't use the linked to tool. current E6440 efi.zip Link to comment Share on other sites More sharing options...
vaccinemedia Posted April 6, 2019 Author Share Posted April 6, 2019 I finally managed to get audio working! It's probably that the latest versions of the Lilu and AppleALC kexts don't accept the legacy injection for the layout-id anymore. I found the following information Quote It should be noted that it's quite likely that Lilu will drop the legacy method of reading the value of "layout-id" from "Clover/Devices/Audio/Inject" at some point in the future, so you may be better of using the second method which uses Device Properties and brings AppleALC configuration in-line with other Lilu plug-in's such as WhatEverGreen. I used Hackintool in order to generate the necessary code to copy and paste into the existing config.plist (removing the placeholders with hashes which were in there from Rehabman's config.plist) and I now have audio! 1 Link to comment Share on other sites More sharing options...
neica Posted April 8, 2019 Share Posted April 8, 2019 I solved Audio on my E6440 with VoodooHDA installer. This is the only tool I use on all my hackintoshes Link to comment Share on other sites More sharing options...
Recommended Posts