shumanak

I cant seem to get audio working on my E6430. I used the applehda kext on Jake's guide. It was working well this morning then I realized that it had stopped working, not sure why. Any ideas would help.

I have been working off that guide, I am having a hard time with clover. I boot into the selection screen, then when I select the usb and press enter nothing happens.

Hello Everyone, I was hoping to get some help installing Mavericks or Yosemite on my Envy 17 model m7-j120dx. I am including my specs. I have tried clover and it wont let me start from the usb installer. Thank you!

That worked great! Two more questions, I don't have battery status working and FileNVRAM.dylib makes it so I can't boot Any suggestions?

I keep getting a KP starting the installer. It looks like it has to do with Intel Power Management?

This is what is being displayed with lspci -nn: 03:00.0 Network controller [0280]: Broadcom Corporation BCM43224 802.11a/b/g/n [14e4:4353] (rev 01)

Jake, I only have Ethernet vpn PPPoE and 6 to 4.

It is enabled in BIOS and is installed correctly. Switch has been in on position.

I also tried switching the white and grey wires.

HDMI WORKS! Thank you. I have a new problem: I ordered a DW1510 and lspci -n shows the Broadcom chip but I do not have a wifi option in settings. I have tried booting the installer and nothing. Thanks for the help!

So my usb ports work almost every other boot, not that big of an issue. I have audio working with VOODOO as well as multi-touch capabilities. I am hoping I can get my HDMI working before I write a tutorial. Do you know what would be a good search to see if anyone else with the IntelHD4600 has their HDMI working?

Thank you for that SSDT worked great! The USB ports work awesome. How would i know which kext will get my audio and HDMI working? Also what are the odds of getting the video out for the charging base to work? If there is no fix no biggie! Thanks!

Thank you very much!

It worked! I am up and running. I only have a couple more questions; my right side usb ports are not working... and every time i try and run the SSDT generator on HVT the installation fails.

As of right now the installer is working, I had to use FB=12. Once it boots, I will let you guys know how it is working. Thanks again for the help. Am i able to create a tutorial for this when it is done?