testes8

Edit: Just going to restart following accidental format Will get it working and will just need to fix the Audio (Internal speaker, do not have faith in the headphone jack). A bluetooth toggle so I can switch it on and off and get the brightness slider to consistently work.

I think I'm going to give up with my plan and try what you said before, and just have SATA II windows and SATA III OS X. So going back to your comment before, reversing the drives. I have put switched the harddrives and booted yet it still has OS X as disk1 and Windows as disk0 (checked using diskutil list). How can I change this? I have it booting to internal HDD which is the OS X one first. Cheers Edit: Interestingly, on Windows (on what should be disk1 installed in the WWAN msata port) according to Paragon partition manager OS X is on disk0 and Windows is on disk1. However when booting I sitll get invalid partition table and when booting into Mavericks it still says OS X on disk1 and windows on disk0

Right, so before I go and change things can I confirm some things with you please as I don't want to corrupt my windows drive? My laptop has 2 mSata ports. A sata III and a sata II. I would like windows (already on an ssd, I don't really want to format it) in the sata III port. And mac osx on a 128gb ssd in the sata II port. What do you mean by reverse the drive? If you mean switch them I'd rather not as that would mean windows would be on SATA II. Is there any way I can get the system the way I want? Can one install chameleon to a boot partition on the windows drive maybe? Or would clover on the osx disk 1 efi partition work? Or any way to make chameleon work on disk 1? Cheers

Hi Jake, I started fresh again as I was getting a few problems and have followed all the instructions through. I generated my SSDT. It doesn't boot without any boot commands now, but it does boot with -f, even though I have run myfix a couple of times. It still says "invalid partition table" on startup. Despite installing Chameleon. When selecting Boot0md, do I want to install it to disk0: Recovery, OS or disk1: Mavericks? I have also run into the same kernel panic as before. Last time it all went wrong when I plugged in my windows ssd and it refused to boot into OSX, I tried to use terminal on the USB and fdisk and mount the OSX partition but would get the kernal panick mentioned before. I would really appreciate any advice, I'm a bit stuck for ideas? Anything I can do with my unmounted EFI partition that could help perhaps? Cheers

Thank you for the speedy reply! I have generated an SSDT, placed it in the extra folder. Used your DSDT from that link, it now boots with just "-f" and no longer needs the "IntelAzul.." What can I do to get it to boot fully? I'm using Chameleon Wizard, and am unsure revision and install method should I be using (I will be dual booting to separate SSD with Windows 7 on). Which boxes do I want ticked in org.chameleon.Boot? Cheers

Hi Jake, I have an E7240, 8gb, 256gb SSD, i5-4310u, Mavericks My machine boots with the "IntelAzulFB=12 -v -f" you wrote above, what should my next step be in fixing this and getting it working properly? I think I need to generate my own DSDT and SSDT as my processor is different, which patches should I apply to it? Any advice on what I should do next? Cheers