Noswal Posted March 16, 2020 Share Posted March 16, 2020 Hi, I just finished getting Catalina clean installed using the Clover Guide and the E7440_Catalina boot pack. My problem is that I'm not able to start the laptop after rebooting. I'm able to boot up properly if I start up using the Clover installation on my flash drive. However, if I start up using the Clover installation on my laptop drive, I get stuck on the Apple logo and without a progress bar underneath. I tried my best to follow the post-install instructions and even tried out different kexts versions, but right now I'm stumped. Can someone please point me in the right direction? I used gibMacOS to download Clover r5092 because I wasn't able to get the latest version to inject the ethernet kext during the OSX install. Link to comment Share on other sites More sharing options...
Administrators Hervé Posted March 16, 2020 Administrators Share Posted March 16, 2020 Make sure you use the same Clover version as your USB installer + same EFI folder... Link to comment Share on other sites More sharing options...
Noswal Posted March 16, 2020 Author Share Posted March 16, 2020 I made sure to also install Clover r5092 on the laptop and copy the same EFI folder from the USB installer to EFI on the laptop. Is there any way to check if these are properly installed? Link to comment Share on other sites More sharing options...
Noswal Posted March 16, 2020 Author Share Posted March 16, 2020 Nevermind. Everything works now. I should have just used the included permissions.sh to refresh the files after copying EFI over. I must have made a typo trying to enter the commands through terminal. Thanks for telling me what I needed to check! Link to comment Share on other sites More sharing options...
Recommended Posts