Jump to content

Permission error linux (BZCAT)


Deathtech
 Share

Recommended Posts

Hello all, Thank you so much for the wonderful guides !

 

Wanted to share my first hurdle with the community.

 

Whilst following your directions to create the image from linux, using "bzcat <image.tar.bz2> > <drive>" bzcat would spit out a permission issue. I searched the forum for keywords bzcat and a few others, but did not find anything, so forgive me if this has been covered, but may warrant a note in the instructions.

 

This also occured when attempting sudo permissions.

 

The resolution is as follows :

 

do a "sudo chmod 666 <driveNode>" and continue with the previous command, and the image should begin writing just fine.

 

Hope I helped with my minor contribution !

 

--DeathTech

Link to comment
Share on other sites

 Share

×
×
  • Create New...