bdesign Posted June 22, 2016 Share Posted June 22, 2016 I have followed the original instructions and also have my E6400 HDD partitioned separately with Linux and Windows and a Mac partition. I can boot to the Clover Loader and then load MAC OSX from USB to install. My issue is, before installing, I go to Disk Utility to format the desired HDD but no drives show up. Only thing I see in Disk Utility is my USB device, no hard drives. How can I get it to show my E6400 HDD?Also, I installed the kexts best I could but I never saw "OEMboard" or any info about that when I launched IORegistryExplorer. Where should that app run from? I tried from the USB device and a separate Mac computer, as I cant run the app on the E6400 as OSX cannot be properly installed on my HDD yet (no HDD's found). Link to comment Share on other sites More sharing options...
Administrators Hervé Posted June 22, 2016 Administrators Share Posted June 22, 2016 Make sure you've set HDD mode to AHCI in BIOS. If your partition table is of MBR type, you may need to apply the MBR patch to your installation. Link to comment Share on other sites More sharing options...
bdesign Posted June 22, 2016 Author Share Posted June 22, 2016 I found the solution to seeing the HDD on the mac install side was to enable AHCI from the bios by hitting F2 at boot and then changing from ATA to AHCI in Hard drive settings (I think). Installing now baby! Link to comment Share on other sites More sharing options...
Recommended Posts