Tyrell Wellick Posted May 13, 2017 Share Posted May 13, 2017 I "successfully" installed EL Capitan on a E6510 but it wont boot without the USB installer? Hence the quotes... I have clover setup with the extract EFI folders from my installer, where am I going wrong? (Outside the fact the guide is for a E6410) I followed this guide http://www.insanelymac.com/forum/topic/308765-guide-dell-latitude-e6410-nvidia-el-capitan-clover-eng/ Any thoughts or help would be much appreciated, thanks for reading this! Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted May 13, 2017 Moderators Share Posted May 13, 2017 Does Clover loader show up without the USB Installer? What error do you encounter? Link to comment Share on other sites More sharing options...
Tyrell Wellick Posted May 14, 2017 Author Share Posted May 14, 2017 No, It says "No boot device found press any key to reboot the machine" I have AHCI enabled & its set on legacy boot. The only time it works is when I boot with the USB installer then when I check clover everything is where it should be. Thanks for the reply! Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted May 14, 2017 Moderators Share Posted May 14, 2017 Hit F12 during boot and select the OS X drive, if that still give you the same error, then you don't have Clover install properly on the the OS X drive. 1 Link to comment Share on other sites More sharing options...
Recommended Posts