mockbuy

Thank you. Originally it was set to 0, and i've tried with -1 for both with the same results, the installer does not show as an option and I only see "reset nvram" I've managed to make it work doing the first installation part of Monterey with an older opencore version, and then replacing it with 0.7.4 to boot again and finish the installation. However, the installer option still doesn't appear in the selection menu.

Thank you for your help. I've used the entire EFI folder from this thread including the config file, I just replaced the serial number, UUID, etc with my previous data. I have tried using the config file "as is" just in case I made some mistake editing it, but I'm having the same problem.

Hi! I'm trying to make a clean install on my HP 840 G3 using your opencore 0.7.4 efi folder. The problem is that the opencore menu only shows the "reset nvram" option, and not the installer. I've tried with big sur and monterrey too, with the same result. If i just replace the efi folder with the 0.6.8 version the big sur installer boots correctly. Any ideas? I'm using a broadcom wifi card, with the normal config plist (not the intel one). Thank you