sacrif

Hi Leon! Thank you for your clear instructions. I followed your guide an my basic WLAN works right now. However I need to switch between multiple Access Points with my wlan card. Therefore I want to adjust the sensitivity value to optimize the timing for switching the AP. In this context I miss certain functionalities using this driver: The command "sudo iwconfig eth2 sens -60" does not seem to be supported and results in the following output: When I use the command "iwconfig eth2" (eth2 is the wlan) I miss informations such as "Signal level" and "Link Quality" which are usually displayed: Interestingly the command "iwlist et2 scan" shows "Quality=51/70" and "Signal level=-59 dBm" So my questions are: Is this missing functionality a general issue of this driver or is more likely to be a problem with my wlan card? Do you have any suggestions to make this functions work? Regards, Mark