Arzakillo Posted November 25, 2017 Share Posted November 25, 2017 is to modify the smbio and does not start. why Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 25, 2017 Moderators Share Posted November 25, 2017 ??? system won't start? Link to comment Share on other sites More sharing options...
Arzakillo Posted November 25, 2017 Share Posted November 25, 2017 I have tried the smbios: iMac 14.1 iMac 14.2 iMac 14.3 iMac 14.4 Imac 17.1 iMac 18.1 Imac 18.2 Imac 18.3 with none of these starts.it always restarts I'm trying all ... Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 25, 2017 Moderators Share Posted November 25, 2017 boot with verbose and debug 0x100 to determine the issue Don't change the SMBios. Just generate a new serial so it's unique. Make sure to use latest Clover Configurator 4.53 and up. Link to comment Share on other sites More sharing options...
Arzakillo Posted November 25, 2017 Share Posted November 25, 2017 I have this problem: Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 25, 2017 Moderators Share Posted November 25, 2017 Restore you original Config file, only generate different serial. Use CC 4.54 and up as stated earlier. Will original Config without changes boot? Link to comment Share on other sites More sharing options...
Arzakillo Posted November 25, 2017 Share Posted November 25, 2017 I have replaced the entire efi folder and it does not start. I'm going to do new installation. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 25, 2017 Moderators Share Posted November 25, 2017 what version of Clover do you have installed? Make sure you have FixHeaders or FixHeaders_200000000 enabled depending on version of Clover installed You can enable it under Clover Options during boot Link to comment Share on other sites More sharing options...
Arzakillo Posted November 25, 2017 Share Posted November 25, 2017 I just made a new installation and I have only generated the code I have rebooted and it does not start again. The versión is 4.56.0.0 Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 26, 2017 Moderators Share Posted November 26, 2017 How about Clover, what version are you running? Make sure minimum v4297 Link to comment Share on other sites More sharing options...
Recommended Posts