Jump to content
PayPal donations: [email protected] ×
pellepirat77

[SOLVED] M4800 touchpad stopped working

Recommended Posts

Hi all!

 

I gave 10.15.4 a try on my M4800.

First updated Clover and extensions like Lilo etc with the help of Hackintool.

 

The update to 10.15.4 went fine, a quick check gave the impression that all important stuff was working fine.

Powered down the computer and left it until today.

 

When I booted it up again the touchpad has stopped working.

 

I tried different versions of VoodooPS2Controller but I no luck...

 

I'm thinking maybe something with the USB has gone haywire so the touchpad isn't detected.

 

It works out in the Clover boot menu, so there is not hardware related...

 

I have most extension installed in /L/E except for BCRM and VoodoPS2 that I have in /E/C/k/Other

 

Anyone with the same issue?

 

 

Share this post


Link to post
Share on other sites

No, touchpad is PS2, not USB related. You probably just need to repair permissions and rebuild cache.

Share this post


Link to post
Share on other sites

Ok, thanks for the tip!

 

However I tried it already and no change. I tried to installing VoodooPS2Controller.kext to both /L/E and /E/C/k/O but no difference.

 

The touchpad works in the clover menu before the os loads...

 

I'll keep looking for a solution tomorrow...

Share this post


Link to post
Share on other sites

Well there was a new version of VoodooPS2Controller (2.1.3) out so I thought that might do the trick but no luck...

If I remove the kext completely the Touchpad is not working in Clovers boot menu, but when I have it in /E/C/k/O then I can move the cursor out in the boot menu, but when I get to the desktop it stops working again...

 

 

 

Share this post


Link to post
Share on other sites

×
×
  • Create New...