11bravo Posted October 18, 2012 Share Posted October 18, 2012 After I installed the EDP package and ran the configuration for my model (18. E6400-6500) I can no longer boot my machine anymore. It gives me teh screen "You have to power down your system and turn back on again" Any ideas where it's going wrong? BTW: E6400 OSX 10.8 Link to comment Share on other sites More sharing options...
11bravo Posted October 18, 2012 Author Share Posted October 18, 2012 Booted off of INstall USB and Ran myFix (Full) Now it just gets stuck at the OSXLatititude boot screen with a "No" symbol above the Icon. Just sit's and spins. Was running fine before, Really not seeing the benefit of installing this EDP software. Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted October 18, 2012 Administrators Share Posted October 18, 2012 boot with -f -v flag at the chameleon prompt and post the error please. Link to comment Share on other sites More sharing options...
11bravo Posted October 18, 2012 Author Share Posted October 18, 2012 Link to comment Share on other sites More sharing options...
11bravo Posted October 18, 2012 Author Share Posted October 18, 2012 Now I'm getting this. Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted October 18, 2012 Administrators Share Posted October 18, 2012 do you have AHCI enabled in bios for sata controller? Link to comment Share on other sites More sharing options...
11bravo Posted October 18, 2012 Author Share Posted October 18, 2012 Yes. Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted October 18, 2012 Administrators Share Posted October 18, 2012 sometimes shutting it off will pass waiting for root. Link to comment Share on other sites More sharing options...
11bravo Posted October 18, 2012 Author Share Posted October 18, 2012 let me reiterate, I installed OSX with out any issues using a Set up USB with MyHack and all was good with no issues until I installed EDP and follwed directions to the T. When I got to the configuration screen to enter my systems configuration I chose "18. E6400-6500" After re-boot now I cannot boot anymore and either get a "Turn off system and start again" screen or when I choose -v it just stops at the screen I'm showing above. Again. All was good until I installed the EDP software. Should I've just left "good enough" alone? Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted October 18, 2012 Administrators Share Posted October 18, 2012 use whatever works best for you. and what you feel more comfortable with. i'm not sure why it did that as i had no hand in making that model bootpack. but did you try shutting off AHCI? if not it might need an older ioatafamily kext. there might be one more but i cant recall right now. im not on a hack at the moment Link to comment Share on other sites More sharing options...
Recommended Posts