Administrators Hervé Posted September 27, 2014 Administrators Share Posted September 27, 2014 Assuming you're trying to install a post-10.9.1 Mavericks version, use the 10.9.1 kext pack published in the 10.9.5-related post of my Precision 670 guide to replace the vanilla kexts. Link to comment Share on other sites More sharing options...
Awan Posted September 27, 2014 Author Share Posted September 27, 2014 I already replaced the kext , so thats is why i am getting this logo ...... well.. i will give further try tomarrow and will let you know, i may do more research on AMD process as well ... Link to comment Share on other sites More sharing options...
Awan Posted September 29, 2014 Author Share Posted September 29, 2014 Herve', finally removed the kernel panic, but still can't start the installation on my AMD system , Once i hit the installation drive , gives the black screen just after the apple logo.. i think this the graphics issue if i am not.. Please let me know what to do to get the installation Link to comment Share on other sites More sharing options...
Administrators Hervé Posted September 29, 2014 Administrators Share Posted September 29, 2014 No, you did not use the 10.9.1 kext pack: 0 downloads at time of writing... Use Chameleon option GraphicsEnabler=Yes too. Link to comment Share on other sites More sharing options...
Awan Posted September 29, 2014 Author Share Posted September 29, 2014 downloaded and replaced vanila kext with it .. result is same no installation start ): Link to comment Share on other sites More sharing options...
Administrators Hervé Posted September 29, 2014 Administrators Share Posted September 29, 2014 You need to repair file permissions after you replace the vanilla kexts and rebuild cache or boot ignoring it... Link to comment Share on other sites More sharing options...
Awan Posted September 30, 2014 Author Share Posted September 30, 2014 Harve' Done every this as per your advise ... still can't start the installation, System re-starts after apple logo, i tried on another AMD same specs system again no success, I don't know what to do now i have done what ever i knew about it... Link to comment Share on other sites More sharing options...
Awan Posted October 3, 2014 Author Share Posted October 3, 2014 Herve', Finaly installed the Mavericks 10.9 Niresh on my AMD, but can't get through after installation, wheel spins for long time (and it is very slow as compare to e6410) more than 30 minutes, then i restarted to use few boot Flags, -v 1.AppleSmartBatteryManager Failed and 2.Firewire GUID 0000000 Invalid ( Firewire in Bios also says 00000000) 3. Still waiting for Root Device same problem is when booted with -s and -x but that also runs for a long time Used PCIRootUID=0 ... did not get any think .. Please Let me know further what to do Link to comment Share on other sites More sharing options...
Administrators Hervé Posted October 4, 2014 Administrators Share Posted October 4, 2014 PCIRootUID=0 is useless, it's the default value... If you want to try other PCI root values, use PciRoot=. Ideally, you should verify your PC BIOS-configured value which can be obtained by looking at the UID parameter of section Device (PCI0) in your extracted raw DSDT. It may also be obtained through Terminal command ioreg -l | grep -15 "AppleACPIPCI\ " | grep UID. To fix the "still waiting for root device" error, try Chameleon option npci=, though it may disappear with the right PCI root value if non-zero. Did you properly replace the vanilla kernel? Filename should be mach_kernel, casing being sensitive... Link to comment Share on other sites More sharing options...
Recommended Posts