Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 Oh by the way, I can access my Linux Mint partition on that same Asus K53E HDD if it helps my case. I wonder if Linux can actually save my Hackintosh partition. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 16, 2018 Moderators Share Posted September 16, 2018 At Clover, select single user mode Enter this command line /sbin/fsck -fy Repeat until exit is 0 Reboot Link to comment Share on other sites More sharing options...
Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 Link to comment Share on other sites More sharing options...
Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 Ok...well I was trying to show you the last two pictures I took but the site won't allow any more uploads... I researched how to get into single user mode and still wasn't sure so I tried a couple ways. I typed in that command and now my laptop gets past the apple logo but hangs on the white screen. Link to comment Share on other sites More sharing options...
Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 ...ok, something happened, the white screen turned back to the apple logo screen (no spinning wheel or progress bar etc..) Standby for update.... Link to comment Share on other sites More sharing options...
Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 ok screen went black.... Link to comment Share on other sites More sharing options...
Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 Screen with apple logo and spinning wheel is on now Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 16, 2018 Moderators Share Posted September 16, 2018 press the spacebar at the Clover GUI Link to comment Share on other sites More sharing options...
Artisto Posted September 16, 2018 Author Share Posted September 16, 2018 well theres a box to check for single mode but then its a guessing game all over again...screen goes black, then back to apple logo and the progress bar of eternity with no hope, i dont get to the screen where im supposed to type that command. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 17, 2018 Moderators Share Posted September 17, 2018 press the spacebar at the Clover GUI Select single user, verbose and debug 0x100 Link to comment Share on other sites More sharing options...
Recommended Posts