doctorultra Posted June 28, 2019 Share Posted June 28, 2019 Hi, is there an efi for 7470 with mojave compatibility available, or can I also use another efi? Thx Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 28, 2019 Moderators Share Posted June 28, 2019 See here Link to comment Share on other sites More sharing options...
doctorultra Posted June 28, 2019 Author Share Posted June 28, 2019 ok thx, what does the below mean? 2) Enable this patch in Config.plist under KextsToPatch if you have: LiteOn, Plextor, or Hynix NVMe Hynix NVMe patch 10.13.x (Bit swap block size 0x10) -Syscl Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 28, 2019 Moderators Share Posted June 28, 2019 Do you have one of those NVMe drive? If so, open the Config.plist with Clover Configurator. Under KextToPatch, look for the patch and uncheck the check mark. It's disable by default. Link to comment Share on other sites More sharing options...
doctorultra Posted June 29, 2019 Author Share Posted June 29, 2019 the mojave partion of my stick will not be shown with the config.plist, that means I cannot choose the installation. With another config.plist, the installation will be shown? config.7z Link to comment Share on other sites More sharing options...
doctorultra Posted June 29, 2019 Author Share Posted June 29, 2019 I´ve solved my problem but now I can boot from the stick but it freeze at the position you can see on the picture Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 29, 2019 Moderators Share Posted June 29, 2019 You need to add HFSPlus.efi or remove the disable option of VboxHfs.efi in the Config As for the hang, try booting with arg until installation is complete -igfxvesa Link to comment Share on other sites More sharing options...
doctorultra Posted June 29, 2019 Author Share Posted June 29, 2019 Sorry I´ve removed already the VboxHFS from the config and after that I have the problem on the screen, nothing happens on the screen the installation hang up. What do you mean with "arg until installation is complete"? Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 29, 2019 Moderators Share Posted June 29, 2019 add the boot arg provided to get to the installation. Installation will require a few reboots until you get to the desktop. Once you can get to the desktop, run the following and reboot normally without the added boot arg sudo kextcache -i / Don't forget to install Clover and copy the EFI bootpack before rebooting Link to comment Share on other sites More sharing options...
doctorultra Posted June 29, 2019 Author Share Posted June 29, 2019 I don´t understand exactly, I have already this problem during the booting of the installation of mojave. The installation hang on the position, what you can see on my pic. Which boot flag do you mean? Link to comment Share on other sites More sharing options...
Recommended Posts