hassan9311 Posted July 22, 2019 Author Share Posted July 22, 2019 Yes just saw it , I did all as instructed i created a vanilla usb installer and used the bootpack you kindly provided along with the guidance of selecting clover booloader specific and still it does the same enters the screen in the photo i uploaded Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted July 22, 2019 Moderators Share Posted July 22, 2019 Try different ports or different USB. I'm not even sure how to get to that screen even if I try. Can you upload or replace the screenshot with a better quality? It's really blur Link to comment Share on other sites More sharing options...
hassan9311 Posted July 22, 2019 Author Share Posted July 22, 2019 Im sorry the photo is not fully clear the camera wont focus on the laptop screen , i tried all usb ports there is only 3 on the laptop same thing it wont pass this screen under any variation , in this menu when i select boot manager it only shows efi hdd , Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted July 22, 2019 Moderators Share Posted July 22, 2019 Ok, after some research I think that is the EFI boot manager. When you boot with F12, did you select the USB drive from under Legacy or UEFI? You should select it under the latter. Link to comment Share on other sites More sharing options...
hassan9311 Posted July 22, 2019 Author Share Posted July 22, 2019 the usb stick only appears in usb legacy Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted July 22, 2019 Moderators Share Posted July 22, 2019 Sounds like you didn't format your USB correctly. Make sure to format it to GUID / Journal Extended before recreating the Installer Link to comment Share on other sites More sharing options...
hassan9311 Posted July 22, 2019 Author Share Posted July 22, 2019 it was indeed the guid partition jake ,however once i select the installer partition in clover it enters a black screen only any suggestions ? Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted July 22, 2019 Moderators Share Posted July 22, 2019 at clover, press spacebar. Enable verbose and debug 0x100 mode to see where it hangs it's most likely graphics issue. in that case, boot with -igfxvesa you can add it by going into Options during boot by pressing O Link to comment Share on other sites More sharing options...
hassan9311 Posted July 22, 2019 Author Share Posted July 22, 2019 this is what it shows in verbose mode Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted July 22, 2019 Moderators Share Posted July 22, 2019 If you only have 1 memory module, make sure it's on the 1st slot. You'll have to take off the cover on the bottom to check or in the BIOS. Link to comment Share on other sites More sharing options...
Recommended Posts