Babon Posted November 11, 2019 Share Posted November 11, 2019 Done MacBook Pro HDMI connected.zip Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 11, 2019 Moderators Share Posted November 11, 2019 try this one config.plist.zip Link to comment Share on other sites More sharing options...
Babon Posted November 12, 2019 Share Posted November 12, 2019 No, This is not help. The same "No Signal" Link to comment Share on other sites More sharing options...
Babon Posted November 12, 2019 Share Posted November 12, 2019 I tried on ULTRAWIDE monitor. And then I thought maybe there is a resolution limitation. Next I connected to Full HD monitor and nothing happened. When I click FN+F8 on CLOVER menu the HDMI monitor is working well, laptop display is blank, and after loading MacOs both are blank, when I connected the DP (over type-c) monitor (DP connected) is working well. And I can't enable the laptop dispaly (pressing Fn+F8). I have to restart. Maybe this will helpfull. If it's possible to connect this laptop through VGA connector I'll happy Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 12, 2019 Moderators Share Posted November 12, 2019 try this one config.plist.zip Link to comment Share on other sites More sharing options...
Babon Posted November 12, 2019 Share Posted November 12, 2019 This is not help. FYI, there are a lot of such errors. 'gprw namespace lookup failure', but MacOs is loaded ok. This error was from the beggining with different configs. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 12, 2019 Moderators Share Posted November 12, 2019 can you post your clover folder? try switching smbios to MBP15,2 Link to comment Share on other sites More sharing options...
Babon Posted November 12, 2019 Share Posted November 12, 2019 Here it is. I'm using MBP15,2 CLOVER.zip Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 12, 2019 Moderators Share Posted November 12, 2019 Hmm, I was assuming you're using the same or similar files as envy0311. You're using the similar renames but without the dependent SSDT-xxx At least add this to patched folder and try the Config files again SSDT-XOSI.aml.zip Link to comment Share on other sites More sharing options...
Babon Posted November 12, 2019 Share Posted November 12, 2019 No, this is not working too. Link to comment Share on other sites More sharing options...
Recommended Posts