dirtyb15 Posted August 28, 2020 Share Posted August 28, 2020 Just out of boredom, was trying to use opencore instead of clover. I am successfully able to boot now with Opencore, but have not gotten audio to work as of yet. Attached are my OC config, and Clover config. Anything obvious i am missing in the config? Thanks! Configs.zip Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted August 28, 2020 Moderators Share Posted August 28, 2020 woh! Your audio layout-id is all over the place. With clover you have layout-id set to 6 but Audio inject set to 11 With OC, you have layout-id set to 1 but boot arg alcid set to 7 Check in IOReg file when running in Clover or when audio is working to see which layout-id is correct Link to comment Share on other sites More sharing options...
dirtyb15 Posted August 28, 2020 Author Share Posted August 28, 2020 Thanks Jake for the reply. In IOReg says layout id is 7. I have tried setting it to 7 in OC, but no luck yet. ( I also did not send my most current Clover config, that was on my usb installer. I must have changed it after i put on the local disk efi. In that config, both inject and layout are set to 7.) Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted August 28, 2020 Moderators Share Posted August 28, 2020 Then you probably need the IRQ patch. Look up SSDT-HPET.aml + ACPI patch. Link to comment Share on other sites More sharing options...
dirtyb15 Posted August 28, 2020 Author Share Posted August 28, 2020 Ok thanks, ill give it a shot Link to comment Share on other sites More sharing options...
dirtyb15 Posted August 29, 2020 Author Share Posted August 29, 2020 Still no luck, im sure I'm messing something up. I have tried to look at as many examples as i could find, and have been going through the opencore/laptop guide. I don't even see any audio devices listed in hackintool. Any obvious issues with my config? Thanks again for the help. OC.zip Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted August 29, 2020 Moderators Share Posted August 29, 2020 In this config you have alcid=6 Thought you said it should be 7 keepsyms=1 alcid=6 dart=0 Also you're missing SSDT-XOSI.aml Link to comment Share on other sites More sharing options...
dirtyb15 Posted August 29, 2020 Author Share Posted August 29, 2020 6 seems to work better in clover, i was having issues with my microphone using 7. I have added SSDT-XOSI. In clover, using hackintool i can see two sound devices (Realtek ALC269, and Intel HD4000 HDMI). With OC, so far i have never seen any devices show up under the sound tab. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted August 30, 2020 Moderators Share Posted August 30, 2020 In the Config, change the count # for XOSI to 0 Link to comment Share on other sites More sharing options...
dirtyb15 Posted August 30, 2020 Author Share Posted August 30, 2020 Thanks, tried setting count to 0. Did not notice any difference. Attached is the latest i have been trying. OPENCORE.zip Link to comment Share on other sites More sharing options...
Recommended Posts