Specs: Core i5-10310U UHD 620 13.3 FHD 16GB RAM Intel AX201 ALC295/ALC3254 macOS Ventura 13.6.6 Opencore 0.99 I believe I have everything working on this laptop except sleep. I mostly followed the opencore guide, and used the files helpfully provided in hidematu5310's post for the trackpad, which is working fine. Unfortunately, the laptop KPs when I try to get it to sleep. In troubleshooting this Sleep problem, I have tried: -setting the pmset variables per Dortania's guide -removing and renaming hibernate file to /dev/null -re-did the usb mapping using corpnewt's USBMap, and verified in IOReg explorer that the designated ports had the correct comments, and the unused ports are gone -verified Power Management is working (X86PlatformPlugin attached) -double checked GPRW patch applied (although this issue isn't instant wake) -built SSDT-PLUG manually -built SSDT-AWAC-DISABLE manually -tried CPUFriend/CPUFriendDataProvider per Dortania's guide None of these have resolved the KP. I would very much appreciate any suggestions. I've attached my OC folder (kexts removed)- OC.zip

I tried it with both Enable and Disable Block Sleep. hibernatemode 3,25 twice each. I put it in sleep for at least 5 minutes and then wake. There was no difference between each. pmset -g stats Sleep Count:2 Dark Wake Count:0 User Wake Count:2 When I tested hibernatemode 25 with SSDT with deep idle enabled, I got a loop condition where it rebooted and then went to sleep, so I tested with SSDT with deep idle disabled. If you want to use hibernate 25, use SSDT with deactivated deep idle because it is likely to conflict with deep idle. Use SSDT regardless of whether Block Sleep is on or off. Wake is also easier than with hibernate 3 because you can wake with the power button. Is pmset restored to default? Check if sleepimage is created in /var/vm. Update: I did a battery drain test for 1 hour each. hibernatemode 25 100% -> 100% hibernatemode 3 100% -> 85% Update 2: It is now possible to resume using the Power Button from S3. Low Power S0 Idle Capability: Disabled setup_var_cv Setup 0x14 0x1 0x0 Currently working on improving the battery drain in S3. Update 3: hibernatemode 3 battery drain test for 1 hour. Set standbydelay to about 5 minutes(300). 100% -> 98% Update 4: Fixed a potential problem where trackpad would stop working after rebooting from Windows or after Wake. Update 5: probably fixed instant wake on AC recommended to add darkwake=0 SSDT-S3_upd5.zip