in.abhi9 Posted April 2, 2017 Share Posted April 2, 2017 Hello, I recently installed sierra 10.12 using this guide with EFI v3556 and Clover v2.4 r4003. Everything works smooth so far; also installed latest voodoo2controller by Dr. Hurt. So no issue so far in terms of usage except these two, 1) Some times while using with HDMI and switching between display it gets restarted. It gets rebooted if HDMI is connected, the lid is closed while booting and after boot when the lid is opened. 2) It cannot get into sleep mode; I followed instruction given in the mentioned guide. It wakes up immediately after sleep, tried removing ethernet cable, hdmi and USB. I receives this message in log kernel: (AppleACPIPlatform) Wake reason: GLAN HDEF (Network) Any help? Thanks in advance. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted April 2, 2017 Moderators Share Posted April 2, 2017 Replace files with this for Sierra. You should use the latest Clover, older might cause issue with current 10.12.4. Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted April 2, 2017 Administrators Share Posted April 2, 2017 make sure you have ethernet "wake from lan" disabled in bios if you have the option also disable network boot. Link to comment Share on other sites More sharing options...
in.abhi9 Posted April 2, 2017 Author Share Posted April 2, 2017 Wake from lan was already disabled. I tried disabling network boot and disable LAN entirely though it didn't help and re-wakes immediately Link to comment Share on other sites More sharing options...
in.abhi9 Posted April 2, 2017 Author Share Posted April 2, 2017 Replace files with this for Sierra. You should use the latest Clover, older might cause issue with current 10.12.4.I'm using that files only and r4035. I'll try latest and let you know Edit: Tried latest clover r4051 but both problem still persists. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted April 2, 2017 Moderators Share Posted April 2, 2017 Sleep should work without power adapter. Link to comment Share on other sites More sharing options...
in.abhi9 Posted April 3, 2017 Author Share Posted April 3, 2017 Yes, you are correct it works without power adaptor. Though it's strange!Thank you! Can clue on reboot upon opening lid issue? Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted April 3, 2017 Moderators Share Posted April 3, 2017 I don't have that issue. Do you have HDMI connected but don't have HDMI patch enabled? The patch is enabled in the files I linked above. Link to comment Share on other sites More sharing options...
in.abhi9 Posted April 3, 2017 Author Share Posted April 3, 2017 Yes I've that file only in my CLOVER dir. Steps to reproduce. 1) Plug HDMI in, close the Lid and reboot 2) Let it start with closed Lid and plugged HDMI 3) Try to open lid with HDMI connected Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted April 3, 2017 Moderators Share Posted April 3, 2017 Nope, still not experiencing such issue. Try resetting your BIOS to load Default, apply and then set to UEFI/AHCI. Update: fix the sleep issue with power adapter. Files re-uploaded Link to comment Share on other sites More sharing options...
Recommended Posts