Kjescha Posted November 1, 2017 Share Posted November 1, 2017 Hi, I'm trying to install HS with Clover on my E6440 in UEFI mode. I followed Jake Lo's installation guide and created a usb installer using the appropriate Sierra bootpack from the same thread. I also applied the changes for HS to config.plist. I can boot from the installer, but clovers boot screen doesn't show any devices. Any advice? Link to comment Share on other sites More sharing options...
Administrators Hervé Posted November 1, 2017 Administrators Share Posted November 1, 2017 Did you format the USB installer MBR? I'd recommend that. You should then be able to see the "macOS Install from ..." disk partition in the Clover list once the bootloader has loaded. Link to comment Share on other sites More sharing options...
Kjescha Posted November 1, 2017 Author Share Posted November 1, 2017 No, I always used GUID formatted usb installer, but will try MBR later. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 1, 2017 Moderators Share Posted November 1, 2017 You need HFSPlus.efi in /EFI/Clover/drivers64UEFI which is included in the Generic EFI from my guide Note: Bootpack (EFI) consists of combining the Generic EFI + the model you're downloading!!! Instruction: Download the Generic EFI folder. Download model below and add the contents into the Generic /EFI/Clover folder Link to comment Share on other sites More sharing options...
Administrators Hervé Posted November 1, 2017 Administrators Share Posted November 1, 2017 I had assumed Kjescha did read the guide and added all required modules as per the instructions... Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 1, 2017 Moderators Share Posted November 1, 2017 Even with big RED Bold fonts, some still look pass it. I might have to revise the guide if this keeps appearing Link to comment Share on other sites More sharing options...
Administrators Hervé Posted November 1, 2017 Administrators Share Posted November 1, 2017 Link to comment Share on other sites More sharing options...
Kjescha Posted November 2, 2017 Author Share Posted November 2, 2017 Yes, either HFSPlus.efi or remove the entry VBoxHfs from disable drivers section in config.plist. @Harve: Why do you prefer MBR over GUID? Link to comment Share on other sites More sharing options...
Administrators Hervé Posted November 2, 2017 Administrators Share Posted November 2, 2017 Let's say that I've had issues booting HighSierra USB installer set with GUID scheme, not when they were set with MBR scheme. Link to comment Share on other sites More sharing options...
Kjescha Posted November 2, 2017 Author Share Posted November 2, 2017 Oh, ok. Finally, I have installed HS on my E6440 after Jake Lo's hint about the generic bootpack. I guess I mixed up the meaning of "Sierra bootpack only" on step 2 when I created the usb installer. Thanks for your help guys Link to comment Share on other sites More sharing options...
Recommended Posts