Moderators Jake Lo Posted May 8, 2018 Moderators Share Posted May 8, 2018 It was assumed you have the correct BIOS setting already since you had Sierra running perfectly, not much difference for HS. But just to be sure, E6430 runs perfectly fine with UEFI. Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 Yes it worked without problems. After the HS install when booting again and selecting install high sierra it again it just loads 5% if the loading bar with apple logo and reboots itself and keeps cycling that NEVER MIND THE MESSAGES BELOW THIS. SKIP TO THE NEWEST POST Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 I’m just so stupid at these things. I need lots of help. I would probably need own instructions with 1-10... instructions that work with my pc. Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 If you can help using Skype or some other messaging service. If you would have time later today. It’s so slow to write in this topic 8 hours ago, Jake Lo said: It was assumed you have the correct BIOS setting already since you had Sierra running perfectly, not much difference for HS. But just to be sure, E6430 runs perfectly fine with UEFI. Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 SO, 2) Install Clover with following config, add appropriate Sierra bootpacks Only + Generic EFI from post #2 above ( See note1 below for updating bootpack for HS) UEFI: Install for UEFI booting only Install Clover in the ESP Drivers64UEFI\OsxAptioFixDrv-64 Using this clover config when installing it to the USB. What bootpacks do i now need to move and where? Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 So i did the working boot loader. It loads ok to setup. When i press install it installs till there is 2 minutes left. Then it restarts and i choose the same usb setup. But it goes back to the same screen where you can start install? Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 FIXED the issue that i mentioned one post up. I fixed it by booting from preboot instead of the same install os x high sierra. Now it is installing. NOW: I expect that i will have nothing working. Give me the usual links to kexts to this PC. If you could name what fixes what and where do i move that kext. Thank you, REALLY THANK YOU Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 Done. Now i just need the kexts. I did everything according to the post install in your post Link to comment Share on other sites More sharing options...
Elbe556 Posted May 9, 2018 Author Share Posted May 9, 2018 Ok so it kind of rebooted ok. First reboot it got stuck in a graphics glitch. After that i rebooted. It made the glitch again but then booted fine... The touchpad does not work properly. The buttons below touchpad aren't working. If i want to use touchpad i have to apply force.. Audio is not working. Voodoo should fix that? Also hdmi and webcam. How to fix that and the graphics issues? Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted May 9, 2018 Moderators Share Posted May 9, 2018 Post your Clover folder for review Link to comment Share on other sites More sharing options...
Recommended Posts