Jump to content

E6540 - Mojave woes


TheOtherOne

Recommended Posts

  • Administrators

To re-focus the thread on tits initial and entitled topic, ALC292 audio on this model couldn't be easier to activate:

  1. vanilla AppleHDA in /S/L/E
  2. AppleALC + Lilu kexts in Clover's Other folder or cached from /L/E
  3. audio layout #12 (0x0C) injected in DSDT or through Clover config

and that's it.

 

This has been listed, relisted, posted and re-posted dozens of time in many E6x40/E7x40 threads. There's absolutely no need to do anything with FBPatcher or anything of the sort. Keep it simple and to the point.

Link to comment
Share on other sites

  • Replies 60
  • Created
  • Last Reply

Top Posters In This Topic

new debug file

I took everything out what was tried with FBPatcher 

after a fresh install I didn't touch applehda

and id 12 is set

no audio

when I open clover configurator the screen flickers and turns black for a second 

i have two drives and at the moment only the Mojave drive is activated. it seems like something is missing from the other efi partition. 

 

debug_29408.zip

Link to comment
Share on other sites

  • Moderators

You have layout-id set to 1 in DSDT, so that's taking precedent. It's showing in your IOReg file too

Here, use this DSDT, I just remove the layout-id and it should take the layout-id from the Config file now.

What happened to the USBPort kext I attached? It's not showing in your debug files

DSDT.aml.zip

Link to comment
Share on other sites

thank you very much for your help, Jake Lo

since I got confused about all the kext flying around and after I read Herves advice, I took everything out just to see from the bottom...

now I add your dsdt.aml and then next...

the subport.kext was on the hdd efi partition now its only the ssd active. I add this one now ...

 

Link to comment
Share on other sites

  • Moderators

Remove USBInjectAll.kext, not needed with USBPort.kext

In Config files, do this under kextToPatch:

  • Disable-> disable port limit inXHCI
  • Enable ->0x0a260006 9MB cursor bytes patch
  • Disable -> SecondStagePatch 10.12
  • Enable -> HDMI-audio (Optional if you want HDMI audio to work)
  • Uncheck AppleIntelCPUPM <- IvyBridge and below only, not for Haswell
Link to comment
Share on other sites


×
×
  • Create New...