Administrators Hervé Posted November 21, 2020 Administrators Share Posted November 21, 2020 Try to boot via single-user mode to rebuild the cache. Link to comment Share on other sites More sharing options...
nickelnoff Posted November 21, 2020 Author Share Posted November 21, 2020 Adding -s for single user mode to the clover options gets to the same point as before and no further Link to comment Share on other sites More sharing options...
nickelnoff Posted November 21, 2020 Author Share Posted November 21, 2020 I noticed that the config.plist from the link above and the one that gets loaded has a few fields that don’t have an actual real serial number: Could this be causing the boot fail? Link to comment Share on other sites More sharing options...
nickelnoff Posted November 21, 2020 Author Share Posted November 21, 2020 Cutting some of the kexts to what I think might be the essentials to get going: AppleALC.kext IntelMausi.kext Lilu.kext NoTouchID.kext USBInjectAll.kext VirtualSMC.kext WhateverGreen.kext SMCBatteryManager.kext SMCProcessor.kext I have attached @Hervé - this ones based on the Clover release you posted earlier with config.plist, acpi and kexts added. EFI.zip Link to comment Share on other sites More sharing options...
nickelnoff Posted November 21, 2020 Author Share Posted November 21, 2020 At the moment the failure is as follows: Link to comment Share on other sites More sharing options...
nickelnoff Posted November 21, 2020 Author Share Posted November 21, 2020 SSDT-EC.aml appears to get past the above. Got back to login screen albeit with no mouse or keyboard control yet. Must have taken out too many kexts. Wish I was better at this... Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 21, 2020 Moderators Share Posted November 21, 2020 No need to take out kexts, you can disable/block them by pressing the spacebar at the Clover GUI. 1 Link to comment Share on other sites More sharing options...
nickelnoff Posted November 21, 2020 Author Share Posted November 21, 2020 Sounds like a good feature - try to remember that for next time. . Thanks for the help @Jake Lo + @Hervé Managed to now roll back to Clover r5122 and running normally again. Quick question - is the Big Sur upgrade working ? Previous version upgrades have been smooth but wouldn't mind knowing up front if this is advised or not. Thanks Link to comment Share on other sites More sharing options...
Administrators Hervé Posted November 21, 2020 Administrators Share Posted November 21, 2020 Proceed with caution; preferably on a separate disk or partition. Use OC off a USB key rather than overwrite your existing Clover EFI partition. But that's a matter for a separate thread. 1 Link to comment Share on other sites More sharing options...
Recommended Posts