PaintArm Posted June 5, 2018 Share Posted June 5, 2018 @Jake Lo It works fine but I get some graphical anomalies from time to time. I don’t have the monitor for the 3020 but do have a monitor with HDMI input. That’s why I have the lead on it’s way. I’ve followed your instructions and am currently watching the install update to HS. Thanks for for your help @Jake Lo @borgiatos @ChrisStocker and @ioncatana A WiFi card is next on my agenda. The board only had 1 PCIe x16 slot and 1 PCIe x1 slot so after the GPU and WiFi card its pretty much a finished project Link to comment Share on other sites More sharing options...
PaintArm Posted June 5, 2018 Share Posted June 5, 2018 So the upgrade went smoothly. Only issue is I have lost all sound. I removed VoodooHDA and AppleHDADisabler as you said but now have lost sound. Sorry to be annoying but any suggestions? Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 5, 2018 Moderators Share Posted June 5, 2018 Replace DSDT.aml with this one DSDT.aml.zip Link to comment Share on other sites More sharing options...
PaintArm Posted June 5, 2018 Share Posted June 5, 2018 I replaced the DSDT with the one you provided and it still didn’t work. I managed to patch the AppleHDA kext file with AppleHDA Patcher and ran it through Kext Utility, restarted and BOOM! Audio was working. The graphics are annoying, videos are very poor. I will look into adding a GPU sooner rather than later I think Thanks again for all all your help guys. Much appreciated Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 5, 2018 Moderators Share Posted June 5, 2018 Try adding https://github.com/coderobe/AzulPatcher4600/releases/download/1.2/AzulPatcher4600.kext.zip to /EFI/Clover/kexts/Other Post IOReg with kext added Link to comment Share on other sites More sharing options...
PaintArm Posted June 6, 2018 Share Posted June 6, 2018 @Jake Lo I had to direct message you the file as I couldn't upload It here for some reason Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 6, 2018 Moderators Share Posted June 6, 2018 Looks like you don't have full QE/CI. Remove /EFI/Clover/ACPI/Patched/DSDT.aml Replace Config with the attached config.plist.zip Link to comment Share on other sites More sharing options...
PaintArm Posted June 6, 2018 Share Posted June 6, 2018 Done. Rebooted but just sits here Link to comment Share on other sites More sharing options...
PaintArm Posted June 6, 2018 Share Posted June 6, 2018 Ok, I managed to get it to boot by editing clover at boot. I set the Graphics Target ID to 0x0d20003 which it was before and set the audio to 3 instead of 15. I have edited the config.plist to reflect this with Clover Configurator. HD 4600 still shows as running with 7mb in About This Mac though......hmmmmmm Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted June 6, 2018 Moderators Share Posted June 6, 2018 Graphics Target ID to 0x0d20003 -> wrong. Should be 0x0d220003 Try this Config Probably should update your Clover too config.plist.zip Link to comment Share on other sites More sharing options...
Recommended Posts