Search the Community

Hi everyone, Got a new D830 but I'm facing multiples issues to get the setup works. It's a sandard Dell D830 Nvidia Quadro NVS 135M serie with Core2Duo T7250 2Go RAM. BUT : The LCD is dead so I've remove it and it's now connected to an external LCD Scrren via VGA outpout AND : No internal Drive, so I use an external USB disk with 1 MBR partition for Windows 8.1 and 1 MBR partition for Mavericks HFS+ journalised. AHCI support (useless in my case) is enabled and the BIOS settings are those given by your Install Guide for D830 systems. I first tried to create an USB install pen with MyHack 3.3.1 but it's stucked at Bluetooth Missing Controller etc… I tried to skip the MBR patch and do it later using InsanelyMac method and I also tried a lots of Boot flags, but no changes. So I create another one with Pandora's box and I can boot fine and install Mavericks. I've noticed that the installer doesn't create a boot file and there's no Extra folder too. Hopefully, because it's just an USB disk I've just plug it in another Mac and did it manually (using MyHack to install the D830 mav bootpack Extra folder). So I can boot and configure the system. But I tried to use EDP post install tool to enable QE/CI on my setup and it just fails. Natit is installed but there's no QE/CI. I've tried to download a fresh Natit kext from OSX86.net (which is strangely 7Mb where the EDP one is about 77 Ko) but it's still the same. I know it's an unusual type of configuration but it should works. Any ideas ? Thanks