mwoertler Posted September 25, 2017 Author Share Posted September 25, 2017 Started with a fresh slate and it worked.... going through install now! Fingers crossed... thank you for holding my hand Link to comment Share on other sites More sharing options...
mwoertler Posted September 25, 2017 Author Share Posted September 25, 2017 Installto the SSD went smooth, upon rebooting to the SSD to begin configuration / installation setup the screen has tons of artifacts on the entire screen that tend to get worse with mouse movement. Is this a sign of something wrong or will it go away once I copy the kexts over? Link to comment Share on other sites More sharing options...
mwoertler Posted September 25, 2017 Author Share Posted September 25, 2017 Screen cap of artifacts Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 25, 2017 Moderators Share Posted September 25, 2017 Hmm, don't remember ever seeing that, but do ahead and finish the post installation, repair permission and rebuild cache. 1 Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted September 25, 2017 Administrators Share Posted September 25, 2017 try sleeping the machine or closing the lid when that happens. or disable inject intel from clover GUI graphics options Link to comment Share on other sites More sharing options...
mwoertler Posted September 25, 2017 Author Share Posted September 25, 2017 Finished post-installation and rebooted, no luck. Attempted closing the lid and no luck. Tried disabling injection of Intel ... no luck (got a black screen). I also notice that I don’t have WiFi and cannot add an WiFi adapter... Link to comment Share on other sites More sharing options...
mwoertler Posted September 25, 2017 Author Share Posted September 25, 2017 I’m not sure if these help... but here is my config.plist: Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted September 25, 2017 Administrators Share Posted September 25, 2017 then you probably need to set DVMT you can try lilu kext and dvmt plugin for lilu Link to comment Share on other sites More sharing options...
mwoertler Posted September 25, 2017 Author Share Posted September 25, 2017 I loaded both lilo and dvmtfixup to efi/clover/kexts/other ... no go. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 25, 2017 Moderators Share Posted September 25, 2017 Did you copy the EFI folder from the USB to the Installed drive replace the default created by installing Clover Link to comment Share on other sites More sharing options...
Recommended Posts