Zoi Posted November 14, 2017 Share Posted November 14, 2017 Something is wrong. I can't see this disk in Disk Utility via Sata. But I can see it in installer by USB 3.0 dock. Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted November 14, 2017 Administrators Share Posted November 14, 2017 well try install to it that way then put it back into the machine. Link to comment Share on other sites More sharing options...
Zoi Posted November 14, 2017 Share Posted November 14, 2017 I tried. After graphic installation appears new point in menu - boot Mac OS from disk, but it reboots is a while. Still appears in usb dongle only. Tried another HDD. 100% working Sata port. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 15, 2017 Moderators Share Posted November 15, 2017 boot with verbose and debug 0x100 mode by hitting the spacebar and select it Post the KP Link to comment Share on other sites More sharing options...
Zoi Posted November 15, 2017 Share Posted November 15, 2017 https://prnt.sc/hakscc Can't find - where log is stored? This is what I get if place HDD inside a laptop: https://prnt.sc/hakz5s The last page before https://prnt.sc/hakzdy Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 15, 2017 Moderators Share Posted November 15, 2017 USB issue, try this config config.plist.zip 1 Link to comment Share on other sites More sharing options...
Zoi Posted November 15, 2017 Share Posted November 15, 2017 Same. Do I need to reinstall? I just run from old installation with new config Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted November 15, 2017 Administrators Share Posted November 15, 2017 you have AHCI set for sata in bios right? Link to comment Share on other sites More sharing options...
Zoi Posted November 16, 2017 Share Posted November 16, 2017 OK, on default settings with manually enabled AHCI internal disk now discoverable. But I still get panic on pre-last config and "crashed" console output (like in older screenshot) in usbfix config. So I'm on installed os, but can't boot. The problem is the same as above Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted November 16, 2017 Moderators Share Posted November 16, 2017 boot with the USB installer and then select the SSD to boot. Did you copy the Clover folder from the installer to the installed drive? Link to comment Share on other sites More sharing options...
Recommended Posts