piters35 Posted October 20, 2018 Share Posted October 20, 2018 Use any DSDT or SSDT patches for this config ? Or any special settings in BIOS ? I Install Sierra 10.12.6 with all attachted kexts and config .plist but NO HD 4600 acceleration ... I get full resolution 2560x1440 but no graphic accelerated so scrolling is very slow. My Dell XPS 2720 with i7-4770S . What version of clover ? Even try three bios version up to A15 but no progress. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted October 20, 2018 Moderators Share Posted October 20, 2018 Add Lilu.kext + Whatevergreen.kext (latest versions). IntelGraphicsFixup.kext has been deprecated, now part of Whatevergreen.kext. Link to comment Share on other sites More sharing options...
Darkasknight Posted October 23, 2018 Share Posted October 23, 2018 @piters35 @asergey63 I am trying on BIOS A13 now after no success with A15, and I cannot get Clover to start installing with either, it starts up into Clover but once I start the install it pauses for a little bit then restarts to the Dell splash screen. What Clover Settings are you using to get the install completed and booting? thanks! Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted October 25, 2018 Moderators Share Posted October 25, 2018 Reboot back to the Clover installer and select "Install MacOS from ...", might reboot a couple of times before completing Link to comment Share on other sites More sharing options...
Darkasknight Posted October 25, 2018 Share Posted October 25, 2018 @Jake Lo I've tried all 4 of the AMImem fixes, and each one it just stops at all ++++++++ in verbose mode, which causes a reboot. I'm using Sierra using terminal install method and Clover 4700 (most recent), which uefi64 files should be in the clover folder? thanks! I've also switched out VFS for HFS+ and neither work. Can someone upload there working clover zip so i can try it on mine? Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted October 25, 2018 Administrators Share Posted October 25, 2018 if you only have one stick of ram then move it into the other slot. or populate both slots. Link to comment Share on other sites More sharing options...
Darkasknight Posted October 25, 2018 Share Posted October 25, 2018 @bronxteck both slots are populated, will try with just one stick, and try other ram I have hanging around as well tonight. Will report back. thanks Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted October 25, 2018 Moderators Share Posted October 25, 2018 Try adding the RAM description in the SMBIOs section Link to comment Share on other sites More sharing options...
Darkasknight Posted October 25, 2018 Share Posted October 25, 2018 @Jake Lo @Bronxteck Still no luck with trying a combination of the above... Any other ideas? thanks a bunch! Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted October 26, 2018 Moderators Share Posted October 26, 2018 Set your BIOS to load default. Apply. then go back and set it with UEFI, AHCI, Legacy Option ROMs enable, Secure boot disabled Replace attached contents into /EFI/Clover File named Mojave but should work for HS and Sierra. XPS2720_Mojave.zip Link to comment Share on other sites More sharing options...
Recommended Posts