Jump to content
PayPal donations: [email protected] ×
MAHDIANO

Latitude 7490 Catalina Stuck during Installation

Recommended Posts

Just to be sure, you're following the Catalina guide for Catalina, right? Because your initial link pointed to the Mojave guide. Would I be right to assume that you're installing Catalina 10.15.4?

 

I might need to revisit Catalina's installation guide given that there were many issues with the 10.15.4 update. Will try a fresh 10.15.4's installation on the 7490 to see...

  • Like 2

Share this post


Link to post
Share on other sites

The DSDT is not related to the MacOS version, it's related to version of BIOS and BIOS configuration and must be patched using your Native exported DSDT. 

As stated, the DSDT main / only patch is for the Brightness control.

Try this, replace Config file and add SSDT* to /E/C/ACPI/Patched

7490_BrightnessFnKeys.zip

  • Like 1

Share this post


Link to post
Share on other sites


Hello guys,

I would like to share my trouble.
I try to install Catalina (last version 10.15.4) on my 7490 (i5 version)

I followed the guide from Hervé ( tu es Français ?) but I had the same problem than Mahdiano (I was not able to boot to Setup the OS
after the second reboot).
So I removed the DSDT.aml file as Jake Lo suggested and then I added the 7490_BrightnessFnKeys package.

Now the installation is going farest but I'm not able to boot the MacOs

 

I had the following message about GFX ( IMG_4007.jpg)

 

Then i have a KP ( IMG_4006.jpg)

 

Could you please help me ? I have no more ideas now..

 

Thx

 

 

IMG_4007.jpg

IMG_4006.jpg

Share this post


Link to post
Share on other sites

What version of Clover are you using?

What version of Catalina are you installing?

 

If 10.15.4, make sure you use at least Clover r5107 and, as stated in the 10.15.4 news update, you may have to boot with -disableigfxfirmware boot parameter until your installation has fully completed.

Share this post


Link to post
Share on other sites

Hello Hervé,

Thanks for your help.

 

Version of Clover is : Clover_v2.5k_r5103

Version I try to install : Catalina 10.15.4

 

Will try to put the option -disableigfxfirmware ( but first I have to find where I have to set this option ^^)

 

:)

Share this post


Link to post
Share on other sites

Hmmm, i tried Clover r5107 and clover r5117, I have a new problem now.

When I boot on the USB key , I m not able anymore to install ( 1st boot to go to the utility disk aso..)

 

any idea about this (I googled this without success) ?

 

unnamed.thumb.jpg.ca56a228dd920df43c5f742a968f4354.jpg

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...

×
×
  • Create New...