jackal Posted September 17, 2014 Share Posted September 17, 2014 I been searching where to put this topic but I seem to not find any answers. SO i leave it in your hands. I followed the guides and was able to boot into my Dell latitude d630 and was able to make it up to the choose language page then the installer log came up. I did partition my hard drive since I am in here but I haven't been able to go further. I am trying to install Marverick. I tried to save log but I do not have permission. So any tips or tricks would be great. Sorry I am a newbie at this! graphics card in Nvd I don't know wifi but i did disable it! Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 17, 2014 Moderators Share Posted September 17, 2014 Don't patch MBR during the USB Installer build stage. Link to comment Share on other sites More sharing options...
jackal Posted September 17, 2014 Author Share Posted September 17, 2014 ok will try thank you Link to comment Share on other sites More sharing options...
Administrators Hervé Posted September 17, 2014 Administrators Share Posted September 17, 2014 Configure BIOS as per recommended settings in pinned thread. Link to comment Share on other sites More sharing options...
jackal Posted September 17, 2014 Author Share Posted September 17, 2014 I have configured bios to the recommendations on here and I don't get the patch in the mbr? So when i am on my hack loading the file let it load and don't what add anything else? sorry guys i am a newbie and not working with a full head here. Link to comment Share on other sites More sharing options...
Administrators Hervé Posted September 17, 2014 Administrators Share Posted September 17, 2014 Answer Yes to questions about kexts removal, answer No to question about MBR patch installation (i.e. do not install/apply MBR patch). Link to comment Share on other sites More sharing options...
jackal Posted September 17, 2014 Author Share Posted September 17, 2014 Ok i did that, installed but hung froze. Then realized i needed to patch my driver i guess so i put that in my extra. I am currently installing maverick on my hard drive ssd 120 gig. thank you so much if i run into anything ill let you know. Link to comment Share on other sites More sharing options...
jackal Posted September 17, 2014 Author Share Posted September 17, 2014 Ok so i reboot and i go to osx and it apears to boot but i am on osxlatitude and the scroll thingy still working and appears like i am not going anywhere. I wonder what i did wrong. I am following the guide but think i missed a step or two or others. help Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted September 18, 2014 Administrators Share Posted September 18, 2014 hit the spacebar during chameleon loading and type in -v. post the error. Link to comment Share on other sites More sharing options...
jackal Posted September 18, 2014 Author Share Posted September 18, 2014 Ok I did that and says at bottom flow_divert_kctl_disconnect (0): disconnecting group 1 I have pictures I'll try to upload them 1 Link to comment Share on other sites More sharing options...
Recommended Posts