fwz.mhmd Posted September 5, 2016 Share Posted September 5, 2016 Whenever I try to use HDMI cable, I get black screen and the whole laptop freezes, i cant do anything unless i force shutdown. Im using Dell E5440, Core i5, 8GB Ram, 500HDD & Intel HD 4400 Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 5, 2016 Moderators Share Posted September 5, 2016 You need to patch for HDMI otherwise it'll freeze like you have. Please upload your Clover folder, I'll verify if you have it enabled or I could add it. Link to comment Share on other sites More sharing options...
fwz.mhmd Posted September 5, 2016 Author Share Posted September 5, 2016 here CLOVER.zip Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 5, 2016 Moderators Share Posted September 5, 2016 Replace with this config. config.plist.zip Link to comment Share on other sites More sharing options...
fwz.mhmd Posted September 5, 2016 Author Share Posted September 5, 2016 My laptop wont boot now Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 5, 2016 Moderators Share Posted September 5, 2016 Nothing was changed, only added HDMI patch which should not cause this. Can you post the error while booting without cache? Update: Added the patch but was disabled. Reupload Config in previous post. Link to comment Share on other sites More sharing options...
fwz.mhmd Posted September 5, 2016 Author Share Posted September 5, 2016 I rebooted without cache but im unable to see because the screen blacks out in the middle of it Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 5, 2016 Moderators Share Posted September 5, 2016 Boot with the USB installer and restore your Config file or use the one I re-uploaded above. Link to comment Share on other sites More sharing options...
fwz.mhmd Posted September 5, 2016 Author Share Posted September 5, 2016 I cant remember how to boot from usb Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted September 5, 2016 Moderators Share Posted September 5, 2016 Boot with the USB installer you created for the build, select USB from F12, when you see the Clover Gui, select the installed drive. Link to comment Share on other sites More sharing options...
Recommended Posts