Jump to content

[SOLVED] Can't boot clover from HD - E5420


absint0o

Recommended Posts

Hi there,

 

I'm finally managed to install mac os x El Capitan on my E5420, everything is properly working but in the post installation i'm probably doing something wrong, i'm only able to access the OS booting from USB, if i take the USB off and boot from HD i get this message:

 

post-97443-0-28042600-1477349620_thumb.jpg

 

can please someone help me resolve this situation?

 

Thanks and regards!!!

Link to comment
Share on other sites

  • Replies 24
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Hi Jake!

 

I've done that, i run the EFI mounter and mount the EFI drive from the USB drive and from the HD, and copied the EFI/CLOVER folder from the EFI from the USB drive to EFI from the HD.

But before that i installed the Clover as you can see in this picture below:

 

post-97443-0-96585900-1477351038_thumb.png

 

there's an update always asking me to install about EFI firmware, it's something related with this problem?

 

thanks!

Link to comment
Share on other sites

  • Moderators

Try adding a boot option in the BIOS.

Under boot option, create a new boot call whatever  you like and point it to /EFI/Clover/Cloverx64.efi

I was not able to get a similar model to run in UEFI mode, so I stick with Legacy.

Link to comment
Share on other sites

  • Moderators

In the BIOS, you need to set Boot List Option to Legacy since you're installing with Clover Legacy mode.

In the terminal, check if you have corestorage

 

diskutil cs list

 

If yes, you'll need to revert it. Reboot and reinstall Clover according to your settings above, copy the clover files to the new EFI partition.

Link to comment
Share on other sites


×
×
  • Create New...