surenmunoo Posted March 24, 2019 Share Posted March 24, 2019 1 hour ago, Jake Lo said: Re-install Clover on top with the latest version following these settings Install for UEFI booting only Install Clover in the ESP Drivers64UEFI\DataHubDxe-64 Drivers64UEFI\FSInject-64 Drivers64UEFI\SMCHelper-64 Drivers64UEFI\ApfsDriverLoader-64 Drivers64UEFI\AptioMemoryFix-64 Drivers64UEFI\PartitionDxe-64 Once done, check in /EFI/Clover/drivers64UEFI, the following are removed OsxAptioFix2Drv-64.efi OsxAptioFixDrv-64.efi EmuVariableUefi-64.efi OsxFatBinaryDrv-64.efi Thanks for the reply, how do i enable the steps you mentioned above, must i use clover configurator, i am always getting stuck at this stage only, refer to the picture attached Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted March 24, 2019 Moderators Share Posted March 24, 2019 I added the link to the Clover loader installer, just follow the steps. As for the error, use Clover Configurator to open the Config.plist file. Under ACPI, on bottom left, enable FixHeaders. Link to comment Share on other sites More sharing options...
surenmunoo Posted March 24, 2019 Share Posted March 24, 2019 okay so now after clover boot menu it shows the apple logo and loads on the loading bar for about 5 seconds and reboots back into the clover boot menu Link to comment Share on other sites More sharing options...
surenmunoo Posted March 24, 2019 Share Posted March 24, 2019 I am not getting the black command screen anymore just straight to the apple logo Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted March 24, 2019 Moderators Share Posted March 24, 2019 Boot to Clover, press spacebar. Select verbose and debug 0x100 mode to boot This should present you the error before it reboot Link to comment Share on other sites More sharing options...
surenmunoo Posted March 24, 2019 Share Posted March 24, 2019 done that and it ran for some time then back to clover boot menu, refer to the attached of what i am getting, i i add these boot commands cpus=4 and PCIRootUID=1 it starts the whole command running thinng, goes to the apple logo loading screen, loads for 5 seconds then back to the clover boot screen Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted March 24, 2019 Moderators Share Posted March 24, 2019 Post the clover folder in the thread you opened. I'll assist you there Link to comment Share on other sites More sharing options...
Recommended Posts