Leaderboard

Catalina bootpack will run just fine on Mojave. But your question was to get system to automatically boot after time out, so you enter the name of your HDD, not version of MacOS your running. I hope that is clearer.

Give this a try, replace contents into /EFI/Clover Vostro_3446.zip

Hey Folk - here goes first post I have lurked for a number of years and built a number of hackintoshes in the past but recently started looking at getting Mojave installed on my Dell Precision 7510. The specs are as follows: Intel(R) Xeon(R) E3-1505M v5(Quad Core 2.80GHz, 3.70GHz Turbo, 8MB 45W, w/Intel HD Graphics P530) Nvidia Quadro M1000M w/2GB GDDR5 Samsung 950 ProNVMe Drive Samsung 850 Pro 2 TB SSD At the moment I have Ubuntu and data stored on these 2 drives so the M2 interface has been disabled in the BIOS and the 2 TB SSD has been replaced with a new Samsung 860 1TB QVO SSD I am planning on purchasing a Broadcom Wifi card (any advise on what to get appreciated). I have been trying to build this all pretty slowly and understand all steps involved but been struggling to actually do this and have reverted to using an EFI\CLOVER folder that I found on a TM thread (#54). I tried for quite a few hours last night to build up my own EFI\CLOVER from scratch however could never quite get things booting. Not ideally what I wanted to do but I am sure this EFI\CLOVER might be a good starting point. I have disabled the dGPU using modified version of Dell_E6540_UEFI_eGPU_configurator_by_nando4 so I am now trying to get the IGPU P530 working. At the moment "No Kext Loaded" is shown however I have tried setting the AAPL,ig-platform-id to a supportable 191b from the actual 191d This seems to show in IOReg but something is not working or I'm missing something. I've attached EFI and IOReg - any help appreciated nickelnoff-precision7510-200819.zip

Slight change - found the following - Seems to provide me with all working USB ports ! Thanks @Jake Lo Just to confirm P530 is still trouble: To double confirm here is fresh EFI.zip and IOReg. nickelnoff-precision7510-200819-new.zip

Hi all, have been playing around with the driver to see if I can get firmware upload in Mojave to work on my dw1820a without needing windows to upload the firmware. It seems to be working ok , but am still testing to see if it works consistently. Attaching the kexts if anyone else would like to try with their dw1820a. These need to be uploaded to /EFI/CLOVER/Kexts/Other. Make sure you don't have any equivalent kexts in /L/E or /S/L/E. Let me know if you have any success. BrcmBluetoothInjector.kext.zip BrcmFirmwareData.kext.zip BrcmPatchRAM2.kext.zip

sorry, my mistake the 1 screw is for E6220. You'll have to remove all the screws on the bottom except the 2 besides the dock connector.