roniez Posted August 5, 2019 Share Posted August 5, 2019 Hello I am in need of some assistance getting this card to work. I have followed the guide by Hervé and my laptop will not boot if i add the pci parameters in clover. I did manage to get the laptop to boot once with working wifi and everything except the trackpad (but that was due to a faulty config.plist) and i fixed the config plist file and now it will not boot with injected pci device again... I have attached my clover zip and have also attached a screenshot from ioregistry. Any advice or guidence is highley appreciated. the Card is verified to have a 14e4:43a3 (rev 08) Subsystem: 1028:0021 (CN-0VW3T3) CLOVER.zip Link to comment Share on other sites More sharing options...
roniez Posted August 5, 2019 Author Share Posted August 5, 2019 I have now managed to get the device to boot with Hervé's adaptation. How ever wifi says no hardware installed and IOregistry is showing the changes i did via clover. Any suggestions ? Link to comment Share on other sites More sharing options...
Administrators Hervé Posted August 5, 2019 Administrators Share Posted August 5, 2019 Check that the Wifi card is listed in Network PrefPane. If it's not, try and add it manually. Link to comment Share on other sites More sharing options...
roniez Posted August 5, 2019 Author Share Posted August 5, 2019 Not listed and when I press + to add it is now showing in the drop down. Networksetup -createnetworkservice WiFi en1 did not work either Link to comment Share on other sites More sharing options...
Administrators Hervé Posted August 5, 2019 Administrators Share Posted August 5, 2019 Why don't you remove the BrcmAirportFix kext + Clover associated options ? You could also try to declare compatibility with 14e4,4353 instead of 14e4,4331 though it really does the same. Post your debug package. Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted August 5, 2019 Administrators Share Posted August 5, 2019 you might have to physically tape some pins on the wifi card for it to function same might go for BT. Link to comment Share on other sites More sharing options...
roniez Posted August 6, 2019 Author Share Posted August 6, 2019 13 hours ago, Bronxteck said: you might have to physically tape some pins on the wifi card for it to function same might go for BT. Bronxteck can you elaborate? 14 hours ago, Hervé said: Why don't you remove the BrcmAirportFix kext + Clover associated options ? You could also try to declare compatibility with 14e4,4353 instead of 14e4,4331 though it really does the same. Post your debug package. Have attached the debug package now. i did noticed that if i choose ADDDGTP option in clover it will not inject the PCI device properties i manually add. debug_12191.zip Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted August 6, 2019 Administrators Share Posted August 6, 2019 tape pins 54 for BT & 56 for WIFI those are the Enable/Disable pins Link to comment Share on other sites More sharing options...
roniez Posted August 6, 2019 Author Share Posted August 6, 2019 You don't happen to know which pins those are on my card? Or know where I can find a diagram that shows these pins? Link to comment Share on other sites More sharing options...
Administrators Bronxteck Posted August 6, 2019 Administrators Share Posted August 6, 2019 Link to comment Share on other sites More sharing options...
Recommended Posts