Leaderboard

No, not since Mojave. Conversion is automatic. Only APFS is officially supported for macOS installation. If you want to install on an MBR partitioned disk or on an HFS+ partition, you have to use special tricks/special installation method and that's a little complex unless you're an advanced Hackintosher. So, it's best that newbies avoid this...

What bootpack were you using? Try this one, goes into /EFI/Clover for replacing the old

for this model you should have UEFI Enable and Legacy Option ROMs enabled, AHCI enabled. Drive should be formatted with GUID / Journal Extended In Clover folder, remove the following folders: drivers64UEFI and drivers64 Now install this version of Clover with the following settings: Install for UEFI booting only Install Clover in the ESP UEFI Drivers\Recommended Drivers\ApfsDriverLoader UEFI Drivers\Recommended Drivers\AptioMemoryFix UEFI Drivers\Recommended Drivers\AudioDxe UEFI Drivers\Recommended Drivers\DataHubDxe UEFI Drivers\Recommended Drivers\FSInject UEFI Drivers\Recommended Drivers\HFSPlus UEFI Drivers\Additional Drivers\PartitionDxe Install Clover Preference Pane (Optional)

@prsebastian use bootpack from here Hotpatched so not bios dependent

Ok, so: audio codec is ALC256 and should be supported by AppleALC and the relevant layout(s) Realtek RTS5129 may or may not be supported with Sinetek's kext (unfinished project) Sunplus Webcam will work OOB or not at all

You have to enable "KernelPM" in Clover Configurator. I have added it for you. Just replace your "config.plist" with the attached "config.plist" inside your CLOVER folder. config.plist.zip