Jump to content


Popular Content

Showing content with the highest reputation on 03/14/19 in all areas

  1. 1 point
    Hard to read from the raw IOReg file. Try this app and attach the file Also try this config config.plist.zip
  2. 1 point
    @moah11111 Without knowing more info like ethernet, wifi, touchpad, you could start with this Follow the install guide here, use attached bootpack -> goes into /EFI/Clover Inspiron5557.zip
  3. 1 point
    1st of all, let me state that antennas connection bear no relation whatsoever to hardware detection. This being cleared out of the way, did you check if your DSDT would not already inject properies for a totally different wireless card? Very common, especially as one re-uses existing files from another installation. 'been there myself too in the past.
  4. 1 point
    Remove these kexts: AtherosE2200Ethernet.kext NullCPUPowerManagement.kext RealtekRTL8100.kext RealtekRTL8111.kext USBPorts-Exx50.kext VoodooPS2Controller.kext VoodooTSCSync.kext XHCI-unsupported.kext The files you're using seems to be from my Broadwell system E7450. You should use the E7470 file for Skylake. https://osxlatitude.com/forums/topic/9179-dell-latitude-e7x70-clover-uefi-only/?do=findComment&comment=86790
This leaderboard is set to Amsterdam/GMT+02:00
  • Create New...