Search the Community

Hello, using the clover guide I successfully installed Sierra. Nevertheless, I can't boot it from SDD directly only using USB. At the beginning I was getting a KP caused by AppleIntelCPUManagement.kext... I searched here for the patched kext and problem solved... partially... I'm not getting KPs but the system is not starting... I don't have any clue, but based on my previous experience with Yosemite I suspect that it could be related to some kexts not installed properly... any ideas? Regards

Hi all I have a problem with Mac os x 10.6.2 by Hazard (support AMD) on my Eee Pc 1015BX (amd C-50 and 1gb ram.... too slow for new windows).... I have successfully installed with following bootflags: cpus=1 busratio=18 maxmem=1024 arch=i386 -v -f -x (I don't need graphics resolution change because Eee pc is small laptop and minimal resolution fit perfectly) But I stuck when I am normaly booting :-/ and I have tried same bootflags and some others like -s or GraphicsEnabler=No.... Every time I get stuck in same screen :-/ Every time I see this: Panic (cpu 0 caller 0x2a76e6) "version mis-match between Kernel and CPU PM"@.....and some long text..... Then I have there: Kernel Extensions in backtrace (with dependencies): Sk.triaxis.kext.SleepEnabler(1.0.1)@0x1786f000->0x17870fff BSD process name corresponding to current thread: Unknown Mac OS version: Not yet set kernel version: Darwin Kernel Version 10.0.0: Fri Jul 31 22:47:34 PDT 2009; root:xnu-145.1.25~1/RELEASE_I386 system model name: MacPro2,1 (this is Fake ) System uptime in nanoseconds: 1814168 And then.... boot stuck.... for eternity :-/ I don't know what to do :-/

Hello everyone at OS X Latitude, I have added a PCI graphics card to my Dell Vostro 200 Desktop. I got a Nvidea geforce gt 610 pci express card from PNY. My Windows 7 Professional boots fine, but my Mac mountain lion stopped working. It is stuck at [ PCI configuration begin ]. If I plug it into the original on-board VGA port, it works fine. What is the problem behind this? I am using a 1024MB DDR3 card. I know Hervé wrote in his Vostro 200 guide to use a 2GB card, but it was too expensive to I just got a 1GB card. Is there problem because of the Windows. I am using GUID partition layout. First, I installed Mac, then I installed Windows. Somehow, after installing Windows, the computer boots up to Windows by default. The only way to get to Mac is to plug in my myHack USB installer and boot using that. Again, USB booting worked using on-board video card. Is there a problem because I am booting via USB installer to my Mac partition, or because of some graphic card problem. I also remember that right after my Mac Mountain Lion installation(which was before I got my graphics card) that it said Installation Failed. I just ignored it, because it appeared that it was working fine eventhough it said Installation failed.Could that be the case? Thanks vgupta