Tubardus Posted October 9, 2019 Share Posted October 9, 2019 Hello, I have now Mojave on a Latitude 7490. I would like to know how to install Catalina. Must I follow the tuto made by @Hervé or is there a way to update from my actual installation? For example, do I have to install special kext and launch the update software from Apple? Link to comment Share on other sites More sharing options...
Administrators Hervé Posted October 9, 2019 Administrators Share Posted October 9, 2019 If run currently run Mojave or a Catalina beta version, you may simply run the downloaded Catalina installation app and update via that direct route. Clover has fully supported this for years. It's not mandatory to proceed with a fresh/new installation. https://www.insanelymac.com/forum/topic/340581-macos-catalina-1015-is-out/?do=findComment&comment=2692666 Link to comment Share on other sites More sharing options...
Tubardus Posted October 9, 2019 Author Share Posted October 9, 2019 OK. What I understand is that I must first update Clover to the r5093 and then just update normally from system preferences. Is that right? 2/Kaby Lake R/UHD620 Latitude 7490 laptop: initial OS: Mojave 10.14.6 initial Clover: r4919 Catalina offered through the macOS Software Update panel. Updated Clover to r5093 before updating macOS. All Ok on upgrade completion. Link to comment Share on other sites More sharing options...
Administrators Hervé Posted October 9, 2019 Administrators Share Posted October 9, 2019 I felt it safer to update Clover 1st because I was running on a much older version than r5093. But you may use or stay with your existing version, depending on what it is. For instance, I ran Catalina beta with r5035 and r5058 so those older versions than ran Ok for beta releases should be Ok too. Link to comment Share on other sites More sharing options...
Tubardus Posted October 9, 2019 Author Share Posted October 9, 2019 I tried to update Clover. It is now on version r5070 (I don't know why it isn't r5093). Nevertheless while booting on Mojave, it won't show the apple and the computer restarts over automatically When I updated to r5070, I checked that the drivers in UEFI where the same, but I'm stuck now. What can I do? Thanks Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted October 9, 2019 Moderators Share Posted October 9, 2019 Download from here https://github.com/Dids/clover-builder/releases Link to comment Share on other sites More sharing options...
Tubardus Posted October 9, 2019 Author Share Posted October 9, 2019 Thank you @Jake Lo I just did. But I can't use it since I'm blocked on the clover boot manager and Mojave refuses to load. The computer just reboot. Link to comment Share on other sites More sharing options...
Moderators Jake Lo Posted October 9, 2019 Moderators Share Posted October 9, 2019 boot with verbose + debug 0x100 to discover the reboot issue Press the spacebar when you boot to Clover to get those options enable Link to comment Share on other sites More sharing options...
Tubardus Posted October 9, 2019 Author Share Posted October 9, 2019 Ok. Here's all that is showed. Link to comment Share on other sites More sharing options...
Administrators Hervé Posted October 9, 2019 Administrators Share Posted October 9, 2019 All you had to do, was install r5070 with the exact same settings you had (those listed in my guide). You must have messed up the modules... Re-install accordingly. Link to comment Share on other sites More sharing options...
Recommended Posts