BobbBuilder

I enable c state and p state in cm

10.9.1 fixed following optimization guide. Did use myhack, OSXL, and EDP

I started with Snow Leopard upgraded to 10.6.8 after running EDP, downloaded Mavericks and created a Mavericks installer on a separate partition of my hard drive following a YouTube video. Installed it then booted it using bootflag arch=x86_64. Ran EDP on that and almost everything works now. (Followed YouTube video because I couldn't get myhack to work)

I have a D830 Nvidia Graphics and sometimes it can take 5 tries to get it to boot. This is the message I get

SOLVED - Had to install EDP multiple times to get it to work, but now it is fully working. Could you remove Boot Flag -v from the default org.chameleon.Boot.plist for Mavericks on the D830 Nvida

EDP will not open.

No bluetooth module.

Dell Latitude D830 Nvidia Graphics 4 GB Ram Mavericks 10.9.1 I got Mavericks installed but, I have no sound must of the time it is only recognized during some boots. Are there any kext that will make my sound work all of the time?

MyHack will not open.

When I go to install using OSinstall.mpkg it says "The Installer could not install the software because there was no software found to install." Help me please. Dell D830 Nvidia Graphics 4 gigs ram