Jake Lo

Disable SMCDellSensors.kext in Config file, if that still doesn't work try this for touchpad Make sure to make the changes in the Config file it doesn't have th eVoodooPS2Mouse.kext plugin, so disabling in the Config should work otherwise you'll kP VoodooPS2Controller.kext.zip

post ioreg file using ioregistryexplorer.app v2.1 with HDMI monitor connected

please post IOReg file using IORegistryExplorer.app v2.1

Give this a try Replace the whole EFI folder E5570_OC_0.7.4.zip

Not much info, probably better if you have windows running, post dxdiag.exe file

What wifi does it have? What touchpad does it have? What LAN does it have? Need full system's spec....

Have you tried using ig-platform-id from Idle's file here Built-in Mic, you can try adding CodecCommander.kext Wifi- make sure you're using the correct version of Airportitlwm. There's different version for BS, Monterey, Catalina..etc

Just uploaded OC 0.7.4, give that a try This does not include touchscreen, will have to adjust the subport.kext later

You have IntelSnowMausi.kext enabled in the Config file, the kext doesn't exist in your kext folder. You don't need IntelSnowMausi.kext, IntelMausi is enough. Remove it from the Config file What error are you getting that's preventing it from booting? enable verbose to help you diagnose

voodooi2cHID is a satellite kext that only loads with VoodooI2C, so yes, disable both including the plugins. For bluetooth, there are newer kexts, so update them

According to your Config file, you have Bluetoothfirmware and IntelMausi disabled, enable them should fixed those issue As for touchpad, your touchpad is not I2C as far as I know. Disable those 2 kexts. With Acidanthera's VoodooPS2Controller.kext should enable both trackpoint and Touchpad but without multi gestures. You should have 2 finger scrolling at least.

It's possible your HDMI port is not Con1, could be Con2 or Con3 Please post IOreg files using IORegistryExplorer.app v2.1 to better determine

I think Maxd13 is using USBInjectall instead of USBMap or USBPort.kext I can confirm the touchscreen model uses HS08 Try this kext USBPorts_7280.kext.zip

Yes

nope still not disabled. try this one SSDT-NoHybGfx.aml.zip

Try this ssdt SSDT-Disable-DGPU.aml.zip

Your discrete graphics is still enabled. Disable that should help with sleep. For Brightness control don't forget to add SSDT-PNLFCFL.aml, I think Lorys89 posted a few messages back.

Try disabling XhciPortLimit in Config file and then use Hackintool again

Did you mix Config and drivers from different version of OpenCore Try reset NVRam

Either update your kexts, Lilu and AppleALC or add -lilubetaall to boot-arg

Are you connected via DP to DP port?

disable xhciportlimit. I think it was broken some version ago

If it didn't show up in USBMap, then it's not detected properly. Re do your USBMap kext. You might have to enable USBInjectAll.kext to pick up all the ports so you can create USBMaps. Did you check under USB in system report?

It's an RTS525a, try replacing Sinetek-rtsx.kext with this https://github.com/0xFireWolf/RealtekCardReader/releases

No, this thread is about Latitude E7470 so I'm taking about E7470.