Jake Lo

is -disablegfxfirmware needed in boot arg? Check BIOS, make sure Legacy Option ROMS is NOT enable

@ace3 are you able to sleep and wake system with just UHD630? Can you post the BIOS settings and what version?

After you make any changes to EFI, you need to select 'Reset NVRam' at the OC Picker. If you don't see it during boot, press the spacebar. For me acidanthera's VoodooPS2 does not work nor does Rehabman's. Stick with ApplePS2Controller.

@yangxiaolon What sleep issue are you having? Describe the problem. Did you disable Hibernation?

Yes after removing the boot arg Should run it after any changes to the EFI

Added the XOSI, HDEF, HPET and IRQ patches to the DSDT.

Did you do the reset NVRam yet? Use karabiner-Element is the fastest, not tested if it works on BS. See here

try this, remove SSDT-HPET and SSDT-XOSI and from the Config file too or just disable it in the Config file. Replace DSDT with the attached. DSDT.aml.zip

remove from boot arg vsmcgen=1 if still not working, try 'Reset NVRam' in OC picker

In the Config, change the count # for XOSI to 0

I don't have 4k display, only 1080p so no issue on my end. Try this boot arg igfxonln=1

create a kext, I think Hackintool.app has that option

try and see

Might need an EDID patch

In this config you have alcid=6 Thought you said it should be 7 keepsyms=1 alcid=6 dart=0 Also you're missing SSDT-XOSI.aml

Then you probably need the IRQ patch. Look up SSDT-HPET.aml + ACPI patch.

woh! Your audio layout-id is all over the place. With clover you have layout-id set to 6 but Audio inject set to 11 With OC, you have layout-id set to 1 but boot arg alcid set to 7 Check in IOReg file when running in Clover or when audio is working to see which layout-id is correct

post your files

Clover v5120 and 5121 should not be use. Stick with 5119. The kexts are not the issue.

Unless you have set the DVMT in the BIOS, you'll need to enable this quirks under Kernel AppleXcpmCfgLock

Just upgraded to beta5, no issue. Fn + F11 and F12 still works.

If you have those kexts in /L/E prior to upgrade, you don't need to do it again. You just need to repair permissions and rebuild cache, unless the kexts are newer.

We need to see where it's hanging so enabling verbose mode helps. Here, try this config. Verbose and vesa mode enabled, you can remove them after a fully running system Post the KP or error message config.plist.zip

try rebuilding cache and reboot a few times

Assuming you have added the patch correctly, it's not reflecting in the IOReg file. Please note when you make any changes in OC, you need to select 'Reset NVRam' during OC picker. If it's not display, then press the spacebar. If it's still not working, then post your Config file for review